Bissell 8905 Carpet Cleaner User Manual


 
21
Troubleshooting
SmartTemp Ready Light does not illuminate.
Possible Causes Remedies
The SmartTemp switch is not Turn on the SmartTemp switch.
turned ON.
The machine Power Switch is not Both switches must be ON to
turned ON. activate the SmartTemp Ready Light.
Reduced spray or no spray
Possible Causes Remedies
Bladder may be empty. Refill tank with hot tap water.
SmartMix bottle may be empty. Fill with BISSELL Deep Cleaning
Formula for cleaning or water if rinsing.
The filter may be clogged. Clean out Flow Indicator Filter, page 18.
Tanks may not be seated properly. Turn power OFF; remove & reseat tanks.
Pump may have lost prime. Turn power OFF; after 1 minute turn ON
and depress trigger.
The Pump Belt may be broken. Turn the machine OFF and unplug from
the outlet. To check if a Pump Belt has
broken, you will need a flat head
screwdriver. Insert the blade end into
the lower slot of the Belt Access door
to release the lower snap. If necessary,
insert the blade end into the upper slot
to release the upper snap. Examine the
belt for breakage. You should be able
to see the Pump Belt looped around
the motor shaft. If it is broken or
missing, please refer to Replacement
Parts on page 23 before calling
Consumer Services. Complete
installation instructions will
accompany the replacement belt.
DirtLifter PowerBrush does not turn.
Possible Causes Remedies
The Brush Belt or Pump Belt Turn the machine OFF and unplug from
may be broken. the outlet. To check if a Pump Belt has
broken, you will need a flat head
screwdriver. Insert the blade end into
the lower slot of the Belt Access door
to release the lower snap. If necessary,
insert the blade end into the upper slot
to release the upper snap. Examine the
belt for breakage. If broken refer to
pages 19-20.
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
Lift Here
Insert
Screwdriver
Blade Here