Bissell 8905 Carpet Cleaner User Manual


 
7
SmartMix Continued
Replace SmartMix concentrate bottle.
Note: If bottle leaks, check for proper
positioning of o-ring and straw.
Choose the SmartMix setting that fits the cleaning job.
Water Rinse - use for gentle cleaning or for the
final rinse after cleaning.
Normal- automatically provides the best mix of
water and concentrate for most cleaning jobs.
High Traffic- automatically mixes the right amount
of water and concentrate to dissolve tough grime
and heavy soil. Note: Residual cleaning materials left
in carpet from other products may cause excessive
foaming when picked up. If foam is overflowing
tank, move SmartMix dial to “Water Only” position
until the condition stops.
Note: Both the SmartMix Bottle and the clean
water tank must have liquid in them
in order for the machine to spray. If
one tank is empty, the machine will
temporarily lose its prime and not apply
either cleaning solution or water only.
Important:
If you are using the WATER RINSE
setting, fill the Smart Mix bottle with
water also!
The pow-
ered
brush roll at the floor nozzle is designed to enhance cleaning
performance. The bristle pattern lifts out the deep down dirt
while gently grooming carpet fibers. The floating suspension
self-adjusts to all carpet heights and protects your carpet if
you leave the power switch ON. When the machine handle is
in the fully upright position, CarpetSaver automatically raises
the brush off the carpet.
4.
5.
WARNING:
To reduce the risk of
injury, be extra careful
when cleaning stairs.
Make sure machine is
secure and level.
O-ring
Position
Tip:
Deep Cleaning
stairs and high
traffic areas on
a regular basis
can prolong
carpet life.
SmartMix
Dial
When filling bottle or
storing unit, set
dial to:
H
I
G
H
T
R
AF
F
I
C
W
AT
E
R
R
I
N
S
E
N
O
R
M
A
L
DirtLifter
®
PowerBrush
WARNING:
To reduce the risk of fire,
use only BISSELL Deep
Cleaning Formula in your
ProHeat ClearView. Use of
cleaning formulas which
contain lemon or pine oil
may damage this appli-
ance and void warranty.
Chemical spot cleaners or
solvent based soil
removers should not be
used. These products may
react with the plastic
materials used in your
ProHeat ClearView, causing
cracking or pitting.