Filter
Top Products
8
Tank-in-Tank
Our Tank-in-Tank system is designed with a Bladder inside for
clean water. As you clean, the Bladder will empty. Dirty water
collects in the tank outside the Bladder.
Step on handle release to lay the machine handle
down out of the way.
Lift the Tank-in-Tank handle. The handle locks the
lid in place.
Carry it like a bucket to fill at the sink.
Note: You may notice hair and debris deposits on
the carpet that were loosened by the
brushing action (especially with newer
carpets that have never been deep cleaned
before). This debris should be picked up
and thrown away. Debris that deposits in
the Brush Belt should be cleaned between
uses to keep the Belts running free.
Set the tank down and rotate the handle forward to unlatch
the lid. Lift off and set the lid aside.
Find the mouth of the Bladder and fill to the bottom of the
neck with clean hot tap water. *Do not boil or microwave
water as it can destroy the Bladder.
Note: Fill the Bladder with clean hot tap water only.
Replace the Tank Lid matching the lid and tank edges. Handle
must be in the forward position to reinstall.
Rotate the handle to the carrying position to re-latch
the lid.
Replace tank in machine base, seating firmly in place.
Rotate handle back down to the latched position.
Note: Both the SmartMix Bottle and the clean
water tank must have liquid in them in
order for the machine to spray. If one tank
is empty the machine will not apply either
cleaning solution or water.
Important: If you are using the WATER RINSE
setting, fill the SmartMix bottle with
water also!
1.
2.
3.
4.
5.
6.
7.
8.
9.
Lift and Carry
Fill Bladder only with
clean hot tap water
Rotate Handle to
Unlatch
Latched
3
4
5
9