Filter
Top Products
www.bissell.com 800.237.7691
Assembly
Operations
6
Attach vacuum hose and tools
1. Attach the Twist ‘n Snap Hose by
lining up the tabs on the base with the
corresponding notches on the back of
the vacuum as shown.
2. Turn the Twist ‘n Snap Hose to the right
to lock the hose into place.
3. Grasping the Quick Reach Handle,
slide the end of the Hose Wand onto
the Hose Wand Base. Snap the Hose
into the Hose Clip.
NOTE: The vacuum will not
operate effectively unless the
hose wand is firmly attached.
4. Slide the extension wand and crevice
tool into the storage clip on back
of vacuum.
5. Slide the dusting brush/upholstery tool
into the storage clip on back of vacuum.
6. Store the Pet TurboBrush Tool on the front
of the handle by lining up the base of the
Tool with the base of the holder. Push back
and the Tool will snap into place.
Power switch
The Power Switch is located on the left
side of the vacuum. Push the rocker switch
“ON” (I) to vacuum, and “OFF” (O) when
cleaning is complete.
NOTICE:
For above floor cleaning, the floor
brush will continue to rotate but is
raised above floor. To prevent carpet
damage, do not lean on the vacuum
or let the powerfoot tilt forward.
CAUTION:
To avoid personal injury and
to prevent the cleaner from
falling when cleaning stairs,
always place it at the bottom
of the stairs.
CAUTION:
Before using your vacuum,
make sure that the dirt
container is in the locked
position and that all filters
(pre-motor and post-motor)
are in place. Do not operate
your vacuum without
these filters.
1.
3.
Twist 'n
Snap Hose
6.