Filter
Top Products
14
Form 6104 BCF23-R05
Wire the burner — R7184B
Install the burner and all wiring in accordance with the National
Electrical Code and all applicable local codes or requirements.
Wire the burner in compliance with all instructions provided by
the appliance manufacturer. Verify operation of all controls in
accordance with the appliance manufacturer’s guidelines.
See Figure 11 for a typical wiring diagram, with R7184 oil
primary, for reference purposes only.
Figure 11. - Typical wiring (R7184B)
Legend
FD
Fused Disconnect, by others
TR
Ignition transformer
LM
Limit controls, by others
M1
Burner motor
OP
Operating controls, by others
S1
Oil valve
PR
Oil primary control, R7184 typ.
T-T
24-volt thermostat/limit terminals
CC
Flame sensor, cad cell typical
F-F
Cad cell fl ame sensor terminals
Disconnect electrical power before installing or
servicing the burner.
Provide ground wiring to the burner, metal control
enclosures and accessories. (This may also be
required to aid proper control system operation)
Perform all wiring in compliance with the National
Electric Code ANSI/NFPA 70 (Canada CSA
C22.1).
y
y
y
Electrical shock can cause severe personal in-
jury or death.
Electrical Shock Hazard