Filter
Top Products
R5976255
A
TLAS
CS4 (2001-03)
11-6
11.2.2 Replacing the Filter Pad
The filter pad must be replaced regularly. The operating period of a filter pad depends on the qual-
ity of the supplied air.
! Go to
standby mode
by pressing
STDBY
on the
RCU
! For cooling down the lamp, wait 10 minutes.
! Switch off power by pressing
0
.
Switch off the equipment before replacing the filter pad in order to avoid severe
contamination!
! Lift the cover of the filter pad slightly and remove it.
Figure 11-5
Removing the cover and the filter pad
! Remove the filter pad.
! Insert the new filter pad as indicated on its frame.
! Insert the cover of the filter pad and press it slightly down.
! Switch on power by pressing
1
.
! Switch on the lamp by pressing
standby
or by applying 24V to the
24V interface
.