Filter
Top Products
R5976255
A
TLAS
CS4 (2001-03)
5-9
5.1.5 Lamp Run Time
The operation time of the lamp is 8000 hours. The total hours of operations are counted and can be
displayed on the screen.
The total lifetime of the lamp for a safe operation at high and constant brightness is
about 8000 hours. Always replace with a same type of lamp
5.1.6 Switching to Stand-by
When the projector is running and you want to go to stand-by:
! Press the
STANDBY
key for 2 seconds until the message
'Saving data, please wai
t' is displayed.
Do not press any longer on the
standby
key otherwise the projector will restart.
! Switch off the voltage of the 24V interface.
5.1.7 Switching Off
To switch off:
! Switch off the voltage of the 24V interface or press
STANDBY
key for 2 seconds. When the
message
'Saving data, please wait'
is displayed, do not press any longer on the standby key
otherwise the projector will restart.
! Let cool down the projector at least 10 min.
! Remove the paneling to gain access to the
power
switch.
! Switch off the projector with the
power
switch.
When switching to standby, it is possible to restart within the first 5sec. When not
restarted within these first 5 sec., you have to wait one minute for being able to re-
start again. During the period when restarting is disabled the LED display will show
a jumping square with a dash. When restarting is enabled again, two dashes will be
displayed to indicate that the projector can be restarted.