Filter
Top Products
38 Optional Equipment
Travis Industries 100-01140 4020628
Outside Air Installation (for wood stoves only)
This pedestal has an internal air duct that may be used to direct air to the combustion chamber.
Follow the directions below prior to installing the stove or attaching the pedestal.
! Outside air is required for mobile home installations and in certain localities.
+ Read the section "Outside Air Requirements" in the owner's manual prior to installing outside air.
1 Before placing the stove on the pedestal, determine the location of the hole that is cut through the
floor protection and floor. The illustration to the right details the location where this hole may be cut in
relation to the faceplate of the stove. Cut a hole at least 16 square inches in area that does not
interfere with structural members of the home.
17"
16"
26"
18-3/4"
Outside air may be drawn
from this area underneath
the pedestal
(min. 16 square inches)
Pedestal Base
(without dowels)
Top View
The faceplate of the
Pendleton (745/790) and
Rainier (945/990) is 1-1/8" in
front of the forward edge of
the pedestal base.
FRONT
2 Place the included screen (or other screen) over the hole to act as a rodent barrier. It may be
attached above or below the floor. Secure the screen with the included staples.
OUTSIDE AIR EQUIPMENT
Staples are used to attach
the screen to the floor.
Screen is used to prevent
rodents from entering.
Insulation is used to seal the side
edges of the pedestal .
Cover plate is used to
block off room air .
3 Prop the front of the stove up 12"
and pry out the outside air knockout with
a large screwdriver.
4 The cover plate seals the area
around the air control rod. Remove the
two screws and bridge from the cover
plate. Slide the cover plate underneath
the air control rod and re-attach the
bridge.
Outside Air Knock-Out
Drop Chute
Knock-Out
(990 only)
Rear Blower Knock-Outs
Ashpan Pedestal/Air Boot
Outside Air Knock-Out
(990 only)
DO NOT REMOVE
FRONT OF STOVE
The cover plate has a clip which
attaches it underneath the air control.
Remove the two screws that hold the
bridge to the cover plate. Then replace
the bridge when the cover plate is in
place.
Air Control
Rod
Bridge
Phillips
Screwdriver