Filter
Top Products
Operation 21
© Travis Industries 4070806 100-01191_000
Loading Pellets
Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper
holds approximately 50 pounds of pellets.
To Open the Hopper Lid:
Lift the hopper lid from this handle.
Warning:
The front edge of the
stove top becomes very
hot, do not touch this
area below the handle.
NOTE:
The auger automatically shuts off when the hopper
lid is open. If loading pellets while the heater is on,
make sure to close the lid as soon as possible.
This prevents the heater from shutting off due to
lack of pellets in the firepot.
P
e
t
e
l
s
l
HINT
: To prevent the pellet stove from inadvertently shutting down due to the auger disabling switch, we
recommend pressing the “START” button after reloading the stove.
The Two Modes of Operation
Manual
Manual mode requires the user to turn
the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a
thermostat to control room
temperature. The stove automatically
turns on when the temperature drops
below the thermostat setting. Once the
stove reaches operating temperature,
the stove then runs at the heat output
setting selected.
Switching Modes While in
Operation
Whenever the stove is switched from
one mode to another while in
operation, the stove will enter the "start-
up" sequence for a minimum of 20
minutes.
HIGH
DISCONNECT POWER BEFORE SERVICE
REMOTE
AUTO
MANUAL
H
E
A
T
O
U
T
P
U
T
MED
LOW
AUGER
FAULT
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
Use the mode
switch to
determine the
mode.
These indicator lights
are used to determine
which mode you are in.
NOTE: if using a
modulating remote, this
light will come on to
indicate the remote is
controlling the heater.