A.O. Smith 110 Boiler User Manual


 
Installation and Service Manual Upsilon-Series
7
2 Regulations
The following regulations apply to the installation of A.O.Smith central heating boilers:
Legislation and Regulations.
Gas Safety (Installation and Use) Regulations. All gas appliances must by law, be installed by
a competent person, eg. Members of Gas Safe Register and in accordance with the current
Gas Safety (Installation and Use) Regulations. Failure to install the appliance correctly could
lead to prosecution.
All Gas Safe registered installers carry a Gas Safe ID card and have a registration number.
You can call Gas Safe Register directly on 0800 408 5577.
In addition to the above regulations this appliance must be installed in compliance with the
current IEE Regulations, the Building Standards (Scotland Consolidation) Regulations.
Regulations and byelaws of the Local Water Authority and the Current Health and Safety
Regulation.
Ireland:
- Irish standard 813
The current Electricity at Work Regulation must be complied with and also be in
accordance with the relevant and current editions of the British Standards.
The Upsilon boiler is a certied appliance and must not be modied or installed in any
way contrary to this Installation Manual. Manufacturers instructions must not be taken,
in any way, as overriding statutory obligations.
The Upsilon is a central heating boiler for individual or multiple cascade purposes. These
boilers must be connected according to these instructions and all installation norms in
respect of the part of the boiler to be connected.
Theapplianceisnottobeusedbychildrenorpersonswithreducedphysical,
sensoryormentalcapabilities,orlackofexperienceandknowledge,unlessthey
havebeengivensupervisionorinstructions.
Childrenbeingsupervisedarenottoplaywiththeappliance.
Observe the following rules of safety:
- All work on the boiler must take place in a dry environment.
- Upsilon boilers may never be in operation without their housing, except in connection
with maintenance or adjustments (see Chapter 13).
- Never allow electrical or electronic components to come into contact with water.
Carry out the following tasks in connection with maintenance, etc. to an already-installed
boiler:
- Shut down all programs
- Close the gas isolation valve
- Turn off the boilers electrical isolator switch.