Filter
Top Products
– 6 –
SYSTEM OVERVIEW (Continued)
Memory of Alarm When an alarm condition occurs, the touchpad displays the number(s) of the zone(s) that
caused the problem, and displays the type of alarm (ex. FIRE, ALARM). It remains displayed until
it is cleared by disarming the system (see DISARMING THE SYSTEM section).
Phone Access &
Voice
Response
Capability
Your system may include a voice module that will permit you to access the system via a Touch-
tone phone, either on-premises or by call-in when away. The phone access feature will enable
you to do the following:
• Receive synthesized voice messages over the telephone regarding the status of the
security system.
• Arm and disarm the system and perform most function commands via the telephone, with
voice confirmation provided after each command entry.
Complete information regarding the use of this feature is provided in a separate manual entitled
PHONE ACCESS USER'S GUIDE, which accompanies the voice module.
Paging Feature If the paging feature has been programmed for your system, a pager will respond to certain
conditions as they occur in your system. The pager will display code numbers indicating the
type of condition that has occurred. Refer to the PAGING FEATURE section later in this manual
for detailed information.
Single-Button Paging: The touchpads have a special key (identified as the “D” key) which
may be used to signal a Pager. The message displayed on the pager when this key is pressed is
999–9999. This code could mean “call home”, “call your office”, or whatever you decide this
code will mean. See SINGLE-BUTTON PAGING FEATURE section.
Single-Button
Arming Feature
Check with your installer
if single-button arming is
present in your system
.
If programmed for your system, keys A and B on the touchpads may have been programmed for
single-button arming without the use of a security code, as follows:
Key A, when pressed for 2 seconds, will arm all protection (AWAY mode).
Key B, when pressed for 2 seconds, will arm the perimeter (STAY mode).