Filter
Top Products
– 29 –
TROUBLE CONDITIONS
"Check" and
"Battery" Displays
* Not all systems use
wireless sensors.
The word CHECK on the touchpad's display, accompanied by a "beeping" at the
touchpad, indicates a trouble condition in the system.
To silence the beeping for these conditions, press any key.
1. A display of "CHECK" and one or more zone numbers indicates that a
problem exists with the displayed zone(s) and requires your attention. Determine if
the zone(s) displayed are intact and make them so if they are not. If the problem has
been corrected, the display can be cleared if you enter the OFF sequence (security
code plus OFF key) twice. If the display persists, CALL FOR SERVICE
.
Note:
A display of CHECK 70 on English Display touchpads indicates that the
wiring connection to the external sounder is at fault (opened or shorted), and you
should CALL FOR SERVICE. See “BELL FAILURE” on next page. A display of
CHECK 90 indicates that RF interference may be impeding the operation of wireless
sensors* in the system. See “Rcvr Jam” on next page.
2. If there are wireless sensors* in your system, the CHECK condition may
also be caused by some change in the environment that prevents the wireless
receiver from hearing a particular sensor. CALL FOR SERVICE if this occurs.
IF YOU CANNOT CORRECT A "CHECK" DISPLAY, CALL FOR SERVICE AT ONCE.
TYPICAL "CHECK" DISPLAYS
06
CHECK
AC
ENGLISH DISPLAY TOUCHPAD
CHECK 06
BEDROOM WINDOW
CUSTOM ENGLISH DISPLAY