Filter
Top Products
– 5 –
SYSTEM OVERVIEW (Continued)
Burglary
Protection
Your system provides three modes of burglary protection: STAY, AWAY, and INSTANT, and
allows you to BYPASS selected zones while leaving the rest of the system armed. You must
turn on or "arm" the burglary protection portion of your system before it will sense burglary
alarms. The system also provides a CHIME mode, for alerting users to the opening of protected
doors and windows while the system is disarmed. Refer to the other sections of this manual for
procedures for using these features.
The following table lists the four different arming modes and the results of each.
Arming
Features For Each Arming Mode
Mode Exit Delay Entry Delay Perimeter Armed Interior Armed
AWAY Yes Yes Yes Yes
STAY Yes Yes Yes No
INSTANT Yes No Yes No
Security Codes At the time of installation, you were assigned a personal four-digit security code, known only to
you. You must enter the security code when arming and disarming the system, and when
performing other system functions. As an additional safety feature, other users who do not have
a need to know your code can be assigned different security codes. Refer to the SECURITY
CODES section for procedures on adding security codes to the system.
Fire Protection
The fire protection portion of your security system (if used) is always active and will sound an
alarm if a fire condition is detected. A key on the touchpad will enable you to manually initiate a
fire alarm, if necessary. Refer to the FIRE ALARM SYSTEM section for important information
concerning fire protection, smoke detectors and planning emergency exit routes.
Alarms When an alarm occurs, both the touchpad and external sounders will sound, and the touchpad
will display the zone(s) causing the alarm. If your system is connected to a Customer Care
Center, an alarm message will also be sent. To stop the alarm sounding, simply disarm the
system.