Filter
Top Products
26
Resolute
®
Acclaim Woodburning Stove
2000893
Do not operate the Resolute Acclaim if the glass is
damaged. Use the following procedure for glass re-
placement. Replace glass with MHSC replace-
ment glass only, available from your local dealer.
• Open the door and carefully remove the glass by
removing the two (2) clips (one per side) that hold
the glass panel against the gasket in the arched
door opening. Each clip is held in place with two (2)
Phillips truss-head machine screws. (Fig. 36)
• Examine the gasket that seals the glass to the door
frame. Replace if necessary with gasket obtained
from your local Vermont Castings’ Authorized Dealer.
• The glass used in your Resolute Acclaim is specially
coated on one side with a heat reflecting material.
Examine the replacement glass panel, and notice
the markings along the edge.
• Center the replacement glass panel in the arched
door opening, with the marked side of the glass
panel facing the gasket. There should be a gap to al-
low for expansion and contraction between the edge
of the glass panel and the cast iron.
• Replace the two retainer clips and fasten with the
previously removed screws. Tighten the screws
slowly and evenly; do not overtighten.
The Resolute Acclaim uses rope-type fiberglass gas-
kets to make a tight seal between some parts. With
use, particularly on those parts that move, gaskets can
become brittle and compressed and can begin to lose
their effectiveness. These will need periodic replace-
ment.
All of the gaskets used are made of fiberglass. The
three sizes of replaceable gasket are listed below,
along with their application.
Gasket Size... ...And The Parts It Seals
3/16” The glass to the load door frame
5/16” wire mesh The griddle to the stove top
1/2” The arch and bottom edge of the
inner front stove panel to the front
load door
1/2” The front of the grate to the front
load door
Should you need to change a replaceable gasket, wait
until the fire is out and the stove has cooled. Be sure to
follow the standard safety procedure for working with
dusty materials: wear safety goggles and a dust mask.
The procedure for replacing gaskets is the same,
regardless of the gasket location. Four easy steps are
involved:
1. Remove the existing gasket by grasping an end and
pulling firmly. (Fig. 37)
2. Use a wire brush or the tip of a screwdriver to clean
the channel of any remaining cement or bits of gas-
ket. Use a cold chisel for stubborn deposits.
3. Apply a thin (1/8”) unbroken bead of stove cement to
the newly-cleaned groove.
4. Starting at one end, pack a new gasket into the
groove. Where the two ends of the gasket meet,
ensure a good joint before trimming any excess. Do
not overlap or leave ragged edges. (Fig. 38)
Other gaskets form seals between non-moving parts,
but these are not subject to the same wear and dete-
rioration as gaskets on moving parts. It is unlikely that
you will ever need to replace these gaskets unless the
involved parts are disassembled and then put back
together. In any event, this is a job that should be done
only by qualified service personnel.
ST559
Remove
gasket
11/30/00 djt
Remove gasket, then clean channel with wire brush.
ST560
ST559
Remove
gasket
11/30/00 djt
Cement
Sto
ve Gasket
ST561
Lay a bead of gasket cement then press gasket in
place.
ST625
Res Acclaim
Glass replace
10/1/02 djt
Glass
Panel
Retainer Clip
3/16” Gasket
ST625
Glass replacement.