Filter
Top Products
18
Operation (Continued)
Figure 3-5 – Check Adjustment
Figure 3-4 – Top Flap Compression Rollers
Note – If drive belts are allowed to slip on box,
excessive belt wear will occur.
Push electrical switch "On" to start drive belts.
Move box forward under upper taping head until
it is taken away by drive belts. If box is hard to
move under head or is crushed, raise head
slightly.
If the box movement is jerky or stops under the
upper head, move the side drive belts in slightly
to add more pressure between the box and drive
belts.
4. RUN BOXES TO CHECK ADJUSTMENT
(Figure 3-5)
3. POSITION COMPRESSION ROLLERS
(Figure 3-4)
The top flap compression rollers have an
adjustable slide mounting to provide side
compression through the full range of box
widths.
Manually move box forward so front of box is
aligned with top flap compression rollers.
Adjust the compression rollers against top edge
of box and tighten knobs to secure rollers in
operating position.
CAUTION – Hands can be injured or
caught between compression rollers
and box. Keep hands away from this area
when machine is running.
CAUTION – Be sure all packaging
materials and tools are removed
from the machine before operating.