Filter
Top Products
5
Important Safeguards (Continued)
The "Tape Threading Label", shown in Figure 1-9,
is attached to the left side of both upper and lower
taping heads. This label provides a convenient tape
threading diagram. More detailed tape loading and
threading information is provided in this manual in
the set-up procedure section.
The "Warning-Sharp Knife" label warns operators
and service personnel of the extremely sharp knife
used to cut the tape at the end of the box sealing
operation. The label, shown in Figure 1-8, is
located on the orange knife guard between the
applying roller assembly and the buffing roller
assembly. Never operate taping heads with knife
guard removed.
Before working with the taping heads or loading/
threading tape, refer to Figures 3-1 and 3-2, in
Section II, to identify the knife location. Keep hands
out of these areas except as necessary to
service the taping heads or to load/thread tape.
The following two labels are located on the upper
and lower taping heads. Replacement part
numbers for these two labels are listed in Section II.
Figure 1-9 – Tape Threading Label
Figure 1-8 – Knife Warning Label
The "Caution – Pinch Point" label, shown in
Figure 1-10, is attached next to both compression
roller lock knobs on the upper assembly crossbar.
The label reminds operator to keep hands away from
compression rollers when machine is running.
Figure 1-10 – Pinch Point Caution Label