Filter
Top Products
13
Installation and Set-Up (Continued)
TAPE DRUM BRACKET (Lower Taping Head)
Outboard tape roll mounting
(Alternate Position)
–
Remove the tape drum bracket assembly, stud
spacer and fasteners from the taping head.
Install and secure on the infeed end of the lower
frame, as shown in Figure 2-2B.
TAPE WIDTH
The taping heads on the 800a have been pre-
set to accommodate 48 mm [2 inch] wide tape
rolls. To adjust heads for narrower tape, refer to
Section
II
, "Adjustments – Tape Web
Alignment", page 11.
MACHINE BED HEIGHT
Adjust machine bed height. The case sealer is
equipped with four adjustable legs that are
located at the corners of the machine frame.
The legs can be adjusted to obtain different
machine bed heights from 610 mm [24 inches]
minimum to 890 mm [35 inches] maximum.
Refer to Figure 2-2C and set the machine bed
height as follows:
1. Raise and block up the machine frame to
allow adequate leg adjustment.
2. Loosen, but do not remove, two M8 x 16
socket head screws in one leg (use M6 hex
wrench). Adjust the leg length for the
desired machine bed height. Retighten the
two screws to secure the leg. Adjust all four
legs equally.
BOX SIZE CAPACITY OF CASE SEALER
At its factory setting, the case sealer handles
box sizes up to 620 mm [24-1/2 inches]
maximum height. If larger capacity is needed,
the machine can be adjusted to accommodate
boxes up to 725 mm [28-1/2 inches] high. Refer
to page 27,
"Special Set-Up Procedures – Box
Height Range", for set-up procedure.
Note – Adjusting machine to accommodate
724 mm [28-1/2 inches] high boxes also
increases minimum box size to 210 mm
[8-1/4 inches].
TAPE LEG LENGTH
Taping heads are pre-set to apply 70 mm
[2-3/4 inch] long tape legs. To change tape legs
to 48 mm [2 inch], see "Special Set-Up
Procedure – Changing Tape Leg Length",
page 25.
Figure 2-2 – Conveyor Bed Height Adjustment and Lower Tape Drum Bracket Position