Filter
Top Products
32 Visitor and Community Network Access Concentrator Installation Guide
Figure 19
Removing Wrong Address
To configure additional SuperStack II switches, repeat step 2 through
step 4.
5
After all switches have been selected, click
Set
. Clicking
Set
configures
switches with valid VCN AC and VCN AP IP addresses.
Switches corresponding to invalid IP addresses are not configured with
the VCN AC and VCN AP MAC addresses. Error messages appear in the
ConfApp screen when a
Set
operation is attempted for invalid IP
addresses.Similarly, attempting to
Set
a switch which is not connected to
a VCN AC results in the same error messages.
For each wrong switch address the following message appears:
Error Setting the agent.
Click
OK
to close the message.
At the end of the entire
Set
operation the following message appears to
inform that the set operation is complete and that switches at invalid
addresses are not configured:
End of Setting.
Agents from red lines were not set!
Erroneous switch addresses appear in red at the end of the
Set
operation.