33
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
OPTIONAL INSTALLATION
Step Plate
Make one mark 1” (25 mm) up from
the center of bottom edge of the bottom
section and another mark 2-3/16” (56 mm)
up from the first mark.
Drill a 7/16” (11 mm) hole through the
section at each mark and insert the outside
step plate.
Loosely fasten step plate slide to base with
(1) 1/4” - 20 x 5/8” carriage bolt and nut.
Align inside step plate holes and fasten
from inside using the #8 screws provided.
Install one #8 x 3/4” screw in the bottom
step plate hole. The screw in the top hole
varies with door models.
Use the screw size shown below for your
model door.
a) #8 x 3/4” screw for Model 9100
b) #8 x 1” screw Model 9600/9400
Tighten 1/4”-20-5/8” carriage bolt and
nut.
STEP PLATE OUTSIDE
STEP PLATE INSIDE
7/16” Drill Bit
Power Drill
#8 SCREWS
ASSEMBLED
STEP PLATE
1/4” - 20 X 5/8”
CARRIAGE BOLT
HEX NUT
STEP PLATE
BASE
STEP PLATE
SLIDE
2-3/16”
1”
