16
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Attaching Horizontal Track to
Fully Adjustable Flagangle
To install horizontal track, place the
curved end over the top roller. Align
the bottom of the horizontal track with
the vertical track. Hand tighten the
horizontal track to the flagangle with (2)
1/4”- 20 x 5/8” carriage bolts and (2)
1/4”- 20 flange hex nuts.
DO NOT RAISE DOOR UNTIL
HORIZONTAL TRACKS ARE
SE CURED AT REAR, AS OUTLINED
IN STEP 24, OR DOOR COULD
FALL FROM OVERHEAD
POSI TION CAUSING SEVERE OR
FATAL INJURY.
Level the horizontal track assembly and
bolt the horizontal angle to the slot in
the flagangle using (1) 3/8”- 16 x 3/4”
hex head bolt and (1) 3/8”- 16 hex nut.
Repeat for other side.
NOTE: If an idrive
®
opener will be
installed, position horizontal tracks
slightly above level.
Tighten the remaining carriage bolts
and nuts to complete the horizontal
track installation.
Remove the nail that was temporarily
holding the top section in place,
installed in Step 11.
IMPORTANT: FAILURE TO REMOVE NAIL
BEFORE ATTEMPTING TO RAISE DOOR
COULD CAUSE PERMANENT DAMAGE
TO TOP SECTION.
12
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Hammer
Step Ladder
WARNING
(1) 3/8”- 16 X 3/4”
HEX HEAD BOLT
(1) 3/8”- 16
HEX NUT
HORIZONTAL
TRACK
HORIZONTAL ANGLE
FLAGANGLE
(2) 1/4”- 20 FLANGE
HEX NUTS
VERTICAL TRACK
HORIZONTAL
TRACK
(2) 1/4”- 20 X 5/8”
CARRIAGE BOLTS
