14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
INSTALLATION WITH U-BAR
INSTALLATION WITH U-BAR
Power Drill
7/16” Socket
Driver
Vice Clamps
Phillips Head
Screwdriver
TOP SECTION
WITH OR
WITHOUT U-BAR
CENTER
LINE
OPERATOR
BRACKET
U-BAR
TOP
SECTION
TOP
FLANGE
(2) #12 X 1/2”
PHILLIPS HEAD
SCREWS
VICE CLAMP
NOTE: NOT REQUIRED FOR J-STRUTS.
OPERATOR BRACKET
Operator Bracket
NOTE: Operator bracket must be mounted
and secured prior to installing top section.
IMPORTANT: WHEN CONNECTING A
TROLLEY TYPE GARAGE DOOR
OPENER TO THIS DOOR, A WAYNE-DALTON
OPENER/TROLLEY BRACKET MUST
BE SECURELY ATTACHED TO THE TOP
SECTION OF THE DOOR, ALONG
WITH ANY U-BARS PROVIDED WITH
THE DOOR. THE INSTALLATION OF
THE OPENER MUST BE ACCORDING TO
MANUFACTURER’S INSTRUCTIONS AND
FORCE SETTINGS MUST BE ADJUSTED
PROPERLY.
Locate the center of the top section and
place the operator bracket on top of the
section as illustrated. Align the center
of the bracket with the center line of the
top section. For retro fit applications, the
operator bracket must be aligned with an
existing operator and positioned on the top
section as illustrated.
Install (2) #12 x 1/2” phillips head screws
on the top flange of the operator bracket.
U-BAR INSTALLED: If a U-Bar is installed
on the top section, clamp the bottom
flange of the operator bracket to the U-Bar.
Make sure the bottom flange of the bracket
is held in place, flush against the U-Bar
before continuing.
NO U-BAR INSTALLED: If a U-Bar is not
installed on the top section, continue with
the steps below.
Secure the front of the operator bracket to
the section using (3) 1/4”-14 x 5/8” self
tapping screws. Next, using
(2) 1/4”-14 x 5/8” self tapping screws,
secure the bottom flange of the operator
bracket to the U-Bar (if installed) or section
rib. Remove vice clamps if placed on
operator bracket previously.
NOTE: If you have a 9100 door, use (2)
1/4”- 20 x 11/16” self drilling screws to
secure the operator bracket instead of the
(2) 1/4”- 14 x 5/8” self tapping screws
when securing the operator bracket to
U-Bar.
NOTE: When attaching an operator bracket
to the top section with a U-Bar installed,
apply additional pressure to thread the
fasteners into the U-Bar.
OPERATOR
BRACKET
(2) 1/4”- 14 X 5/8”
SELF TAPPING SCREWS
(4) 1/4”- 14 X 5/8”
SELF TAPPING
SCREWS
OPERATOR
BRACKET
OPERATOR
BRACKET
(5) 1/4”- 14 X 5/8”
SELF TAPPING
SCREWS
U-BAR
U-BAR
U-BAR
FRONT
BOTTOM
FLANGE
TOP
FLANGE
BOTTOM
FLANGE
BOTTOM
FLANGE
FRONT
TOP FLANGE INSTALLATION
INSTALLATION WITH U-BAR
INSTALLATION WITHOUT U-BAR
10
BOTTOM
FLANGE
FRONT OF
OPERATOR
BRACKET
(2) 1/4”- 20 X
11/16” SELF
TAPPING SCREWS
