31
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
INSTALLATION
equally on double spring doors.
NOTE: Single spring applications require
no spring winding on left hand side.
Clamp a pair of vice clamps on the
vertical tracks just above the second
roller on one side and just below the
second roller on the other side. This
will prevent the door from raising or
lowering while adjusting the spring(s).
PRIOR TO WINDING OR MAKING
ADJUSTMENTS TO THE SPRINGS,
ENSURE YOU’RE WINDING IN THE
PROPER DIRECTION AS STATED IN
THE INSTALLATION INSTRUCTIONS.
OTHERWISE, THE SPRING FITTINGS MAY
RELEASE FROM SPRING IF NOT WOUND
IN THE PROPER DIRECTION AND COULD
RESULT IN SEVERE OR FATAL INJURY.
To Add Spring Tension:
The ratchet wheel is made of 10 teeth.
To add spring tension, ensure the
ratchet and socket is set so that it will
tighten counter clockwise on the right
hand side, and clockwise on the left
hand side. Place the ratchet with 5/8”
socket onto the winding shaft, pull down
to add 3/10 of a turn. Watch as three
teeth of the ratchet wheel pass over the
ratchet pawl, creating three “clicks”.
To Remove Spring Tension:
To remove spring tension, ensure the
ratchet and socket is set so that it will
tighten counter clockwise on the right
hand side and clockwise on the left
hand side. It is recommended that a
regular 5/8” wrench be used. Place
the wrench onto the winding shaft.
Pull down on the wrench to relieve
pressure between the ratchet pawl
and the ratchet wheel. Push in on the
pawl to allow the three ratchet wheel
teeth to pass by the ratchet pawl, as
you carefully allow the wrench to be
rotated upward by the spring tension.
Release the pawl to allow ratchet pawl
to engage with the ratchet wheel.
Remove the vice clamps from the
vertical tracks, re-check doors balance
and adjust if necessary. When door is
balanced and adjusted properly, place
the ratchet pawl knobs in the active
position (lower position).
TRACK
VICE CLAMPS
ATTACHED TO
INNER RAIL
OF TRACK
PLACE VICE CLAMPS
ABOVE 3RD ROLLER ON
BOTH VERTICAL TRACKS
PAWL KNOB IN LOWER
POSITION
LOWER POSITION
UPPER POSITION
TorqueMaster
®
Plus Reset
Instructions Continued...
PAWL KNOB IN UPPER
POSITION
RATCHET
WITH 5/8”
SOCKET
END BRACKET
3” EXTENSION
PAWL
WARNING
