Page 9 of 36
COMPONENT REMOVAL
Oven Control Panel (S Model)
WARNING: Always perform the Electrical Lockout/Tagout procedure before removing
any sheet metal panels or attempting to service this equipment. Failure to comply with
this procedure can cause property damage, injury or death.
WARNING: Perform the GAS LOCKOUT/TAGOUT procedure before servicing the unit.
1. Perform the ELECTRICAL LOCKOUT/TAGOUT procedure.
2. Perform the GAS LOCKOUT/TAGOUT procedure.
3. Rotate the yellow gas shut-off knob to the OFF position.
Figure 4: Gas Shut-Off Valve Knob
4. Open the kick panel to gain access to the screw securing the control panel.
5. Loosen the setscrew from the yellow gas shut-off knob and remove the knob.
6. Loosen the setscrew from the temperature control knob and remove the knob.
7. Remove the oven knob ring.
8. Remove the screw securing the control panel.
9. Remove the control panel by lifting the bottom up and removing it from the tab located at
the top of the control panel.
10. Reverse the procedure to install the oven control panel.
11. Test the oven to verify proper operation.
Figure 5: S Model Control Panel Removal
Oven Control Panel (C Model)
WARNING: Always perform the Electrical Lockout/Tagout procedure before removing
any sheet metal panels or attempting to service this equipment. Failure to comply with
this procedure can cause property damage, injury or death.
WARNING: Perform the GAS LOCKOUT/TAGOUT procedure before servicing the unit.
1. Perform the ELECTRICAL LOCKOUT/TAGOUT procedure.
2. Perform the GAS LOCKOUT/TAGOUT procedure.
