A SERVICE OF

logo

Page 5 of 36
GENERAL
INTRODUCTION
Procedures in this manual will apply to all models unless specified. Pictures and illustrations can
be of any model unless the picture or illustration needs to be model-specific.
Before performing maintenance on the equipment, thoroughly read this manual and carefully
follow the instructions in the order given.
Installation
Refer to the Installation and Operation manual for detailed installation instructions.
Operation
Refer to the Installation and Operation manual for specific operating instructions.
Cleaning
Refer to the Installation and Operation manual for cleaning instructions.
Lubrication
The convection motor has sealed bearings and requires no additional lubrication.
TOOLS
Standard
Standard set of hand tools.
VOM with A.C. current tester (Any quality VOM with sensitivity of at least 20,000 ohms
per volt can be used).
Special
Hazardous gas leak tester.
Manometer.
SPECIFICATIONS
Electrical
Voltage - 120/60/1 or 208/60/1 (optional)
Amps - 15 Amps
Frequency - 50/60 Hz