Page 17 of 36
Oven Burner Assembly
WARNING: Always perform the Electrical Lockout/Tagout procedure before removing
any sheet metal panels or attempting to service this equipment. Failure to comply with
this procedure can cause property damage, injury or death.
WARNING: Perform the GAS LOCKOUT/TAGOUT procedure before servicing the unit.
1. Perform the OVEN PILOT ASSEMBLY removal procedure STEPS 1-7.
2. Remove the oven burner assembly from the oven.
3. Remove any residual tape from the fittings and coat the threads with new gas-rated
(yellow) Teflon tape.
WARNING: All gas joints disturbed during servicing must be checked for leaks.
Do not use an open flame. Use a hazardous gas tester or a soap and water
solution (Bubbles indicate a gas leak). Failure to comply can cause property
damage, injury or death.
4. Reverse the procedure to install the oven burner assembly.
5. Test the oven to verify proper operation.
Figure 18: Oven Burner Assembly Removal
Oven Burner Nozzle and Gas Orifice
WARNING: Always perform the Electrical Lockout/Tagout procedure before removing
any sheet metal panels or attempting to service this equipment. Failure to comply with
this procedure can cause property damage, injury or death.
WARNING: Perform the GAS LOCKOUT/TAGOUT procedure before servicing the unit.
1. Perform the OVEN BURNER ASSEMBLY removal procedure.
2. Remove the burner nozzle from the oven burner assembly.
3. Remove the orifice hood and gas orifice from the oven burner assembly.
4. Remove any residual tape from the fittings and coat the threads with new gas-rated
(yellow) Teflon tape.
WARNING: All gas joints disturbed during servicing must be checked for leaks.
Do not use an open flame. Use a hazardous gas tester or a soap and water
solution (Bubbles indicate a gas leak). Failure to comply can cause property
damage, injury or death.
5. Reverse the procedure to install the oven burner nozzle and gas orifice.
6. Test the oven to verify proper operation.
