A SERVICE OF

logo

4 Replacement Procedures 4.19 System board
4-72 [CONFIDENTIAL] TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
7. Set the system board into the base assembly in place and secure them with the
following screws.
M2.5×6C Tapping screw ×2
NOTE: When installing the system board to the base assembly, do not pinch the
harnesses.
After instilling the system board, make sure that the WL SW knob moves
properly.
Set the system board as shown in the figure below.
8. Stick the insulator (SQUARE INSULATOR) in place.
9. Arrange the RJ45 harness in place and set it into the slot of the base assembly.