1 Publication 1771-6.5.132 - June 2000
Appendix
B
Installing and Configuring the ControlNet
Communications Driver
The examples using ControlNet in this manual were performed with a
1784-KTCX15 communication interface card installed in the personal
computer that was used as a programming terminal. This appendix
describes how to install and configure the 1784-KTCX15 card.
Installing the 1784-KTCX15
Communication Interface
Card
Perform the following steps to install the 1784-KTCX15 card in your
personal computer.
1. Set the card’s base memory address location on switches S1 and S2.
2. Set the card’s base I/O space address location on switch S3.
For detailed information on
installing the 1784-KTCX15, refer
to the ControlNet Communication
Interface Card Installation
Instructions, publication number
1784-5.33.
More
D000:0000
Front of Switches
Factory-set address
(recommended setting)
up (1)
S2
S1
down (0)
Front View
Side View
down (0)
up (1)
Front View
Side View
down (0)
up (1)
up (1)
down (0)
S3
240h shown
(adjust for your system)
Front of Switches
