4.3 Port Configuration
This function allows displaying each port’s status. The Link Status in the screen displays the current connection speed and
duplex mode; else this function will show down when the port is disconnected. Press the “Refresh” button to renew the
screen. The screen in Figure 4-4 appears.
Figure 4-4 Port Configuration screen
The page includes the following configurable data; see the table 4-3 description of the Port Configuration.
• Item
Description
• All Ports Jumbo
Frames Setting
The maximum Ethernet frame size the interface supports or is configured,
including Ethernet header, CRC, and payload. Draw the menu bar to select the
mode.
• Disable - The default maximum frame size is 1518
• 4096 Kbytes – Set the maximum frame size to 4096 Bytes
• 9600 Kbytes - Set the maximum frame size to 9600 Bytes
• Drop frames after
excessive collisions
Enable or Disable the device to drop frames once the excessive collisions be
detected.
• Port
Indicate port 1 to port 24.
• Link
Indicate current link status and link speed duplex mode of each port.
• Mode
Allow configuring the port speed and operation mode. Draw the menu bar to
select the mode.
• Auto Speed - Setup Auto negotiation.
• 10 half - Force sets 10Mbps/Half-Duplex mode.
• 10 Full - Force sets 10Mbps/Full-Duplex mode.
• 100 half - Force sets 100Mbps/Half-Duplex mode.
• 100 full - Force sets 100Mbps/Full-Duplex mode.
• 1000 full - Force sets 10000Mbps/Full-Duplex mode.
• Disable - Shutdown the port manually.
• Flow Control
Allow Enable or Disable flow control for selected port.
• Enable – 802.3x flow control is enabled on Full-Duplex mode or
-16-
