DCP200 Profile Controller & Recorder - Product Manual
51-52-25-150, Issue 1 – April 2009 Electrical Installation Page 17
3 Field Upgrade Options
Options Modules and Functions
The available plug-in modules, options and accessories are shown in below:
Table 1. Options & Accessories
PART
NUMBER
DESCRIPTION
IDENTIFICATION
NUMBER
OPTION SLOT 1
Single Relay Output for option slot 1
Single SSR Driver Output for option slot 1
Triac Output for option slot 1
Linear mA / Voltage Output module for option slot 1
OPTION SLOT 2 or 3
Single Relay Output for option slot 2 or 3
Dual Relay Output for option slot 2 or 3
Single SSR Driver Output for option slot 2 or 3
Dual SSR Driver Output for option slot 2 or 3
Triac module Output for slot 2 or 3
Linear mA / Voltage Output for option slot 2 or 3
24VDC Transmitter Power Supply for option slot 2 or 3
OPTION SLOT A
Digital Input for option slot A
Basic Auxiliary Input for option slot A
RS485 Serial Communications for option slot A
Ethernet Communications for option slot A
OPTION SLOT B
Full Auxiliary Input (inc digital input B) for option slot B
OPTION SLOT 4
4-Relay Output for option slot 4
ACCESSORIES
Blue Control PC Configuration Software & Lead
Note:
Modules can be either pre-installed at the time of manufacture, or retrofitted in the field.
CAUTION:
Plastic pegs prevent fitting of older non-reinforced single relay modules (Board
Identification Numbers 637/01 and 638/01). Fitting the older relay modules reduces
the isolation rating to Basic 240V Isolation and is therefore not recommended.
Remove this peg when fitting Dual Relay Modules.
Note:
All dual relay modules have reinforced isolation.
