EN
Chapter 1 Printer Basics 11
3. Follow the instructions on the screen to install the software.
Note Before installation is complete, make sure that there is a check mark
next to “Print a test page” (when the prompt appears).
In Windows 2000, if the “Found New Hardware Wizard” window
reappears before installation is complete, click Cancel.
4. Click Finish.
5. If you are prompted to restart your computer, click Yes. The
test page should print after your computer restarts. If you are
not prompted to restart your computer, a test page should
print immediately.
6. If the test page printed correctly, installation is complete. Click Yes
when prompted to restart your computer. (If nothing prints or if
the test page does not print correctly, see the Troubleshooting
Checklist.)
Windows
Millennium
a. The “Add New Hardware Wizard” window should appear on
the computer display.
b. Select “Specify the location of the driver (Advanced)” and
then click Next>.
c. Select “Search for the best driver for your device.
(Recommended)” and then click the boxes as needed so that
there is a check mark next to “Specify a location:” (and NO
check mark next to “Removable Media”).
d. Place the HP LaserJet 2200 CD in the CD-ROM drive.
e. Under “Specify a location:”, type D:\98ME_USB (where D is
the letter of your CD-ROM drive). Click Next>.
