802.1w Rapid Spanning Tree Protocol (RSTP) 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
Use this field to enable spanning tree.
Read-Only Fields
Figure 13-6. Enabling Spanning-Tree Operation
6. If the remaining STP parameter settings are adequate for your network,
go to
step 10.
7. Use
or the arrow keys to select the next parameter you want to change,
then type in the new value or press the Space Bar to select a value. (If you
need information on STP parameters, press
to select the Actions line,
then press
H to get help.)
8. Repeat step 7 for each additional parameter you want to change.
Note: For information on the Mode parameter, see “STP Fast Mode” on
page 13-26.
9. When you are finished editing parameters, press
to return to the
Actions line.
10. Press to save the currently displayed STP parameter settings. You will
then see the “Switch Configuration Menu” with an asterisk (
*) at the
Spanning Tree Operation line, indicating that you must reboot the switch
before the Protocol Version change (step
5) takes effect.
13-20
