3
To set up a Macintosh as a client on a network using the
EPSON Stylus RIP, your system must have the following
minimum configuration:
• Macintosh Centris,
®
Macintosh Quadra,
®
Performa,
®
Power
Macintosh G3 series, or iMac series
• Ethernet AppleTalk
®
connection to the Macintosh set up as
the EPSON Stylus RIP print server
• 16MB RAM (32MB or more recommended)
• At least 2MB of free hard disk space to install the software
and at least 150MB of free hard disk space for processing
large files
• Macintosh System 7.6.1 or later
• CD-ROM drive
Windows System Requirements
To use your printer in either a standalone or peer-to-peer
network environment, your system should include:
• IBM
®
-compatible PC with 486 or higher processor
(Pentium
®
133 MHz or higher recommended)
• Windows 3.1, 95, 98, or NT 4.0
NOTE:
EPSON Stylus RIP is not supported in Windows 3.1.
•
At least 16MB of RAM (32MB or more recommended)
•
At least 50MB of free hard disk space to install the software
and at least 150MB of free hard disk space for processing
files (more for large files)
•
CD-ROM drive
•
An available parallel port configured as LPT1
SP5000_Supplement.book Page 3 Thursday, September 2, 1999 2:49 PM
