Epson LX-1170 Manual

A SERVICE OF

next previous

53

For LX-1170 users: grasp the pull tractor with both hands. Push

down the tractor onto the mounting slot at the top of the printer

and tilt it into place as shown below. When you push the tractor

onto the posts, you should feel the notches snap into place.

4. Load continuous paper on the sprocket units of the

push-tractor. (See “Printing on Continuous Paper” on page

24.)

5. Turn on the printer. Hold down the LF/FF button to feed

paper in one page.

6. Release the sprocket lock levers of the pull tractor and adjust

the sprocket units to match the width of the paper. Be sure

that the sprocket units on both tractors are aligned so that the

paper is not crooked.

7. Open the sprocket covers. Fit the holes of the paper over the

tractor pins of the sprocket units and adjust the sprocket units

as necessary. (See “Printing on Continuous Paper” on page

24.) Close the sprocket covers.