22 Using the Printer
Manual feed wait time
This sets the amount of wait time between the time paper is
inserted into the paper guide and when it is fed. If the paper feeds
before you can adjust its position to your satisfaction, you can
increase the wait time.
Buzzer (beeper)
The printer beeps when an error occurs. (See “Using the Error
Indicators” on page 85 for more information on printer errors.) If
you do not want the printer to beep when an error occurs, turn
this setting off.
IBM character table
This setting is available only in IBM 2380 Plus (for LX-300+)/ IBM
2381 Plus (for LX-1170) emulation mode. When you select table1,
hex codes 80H to 90H of the character tables are used for the
control codes. When you select table 2,hex codes 80H to 90H are
used for characters.
Changing default settings
Follow these steps to enter the Default Setting mode and change
the printer’s default settings:
Note:
❏ To print the language selection instructions and the Default Setting
mode instructions, you need five or six sheets of A4 or Letter size
single-sheet paper, or five or six pages of continuous paper that is at
least 279 mm (11 inches) long and 210 mm (8.27 inches) wide.
❏ If you use single sheets without an optional cut-sheet feeder, you
need to feed a new sheet of paper each time the printer ejects a printed
sheet.
1. Make sure paper is loaded and the printer is turned off.
