TM
Page 33
Reference manual Foundation Fieldbus Control module
DOC.RM.QC34.E Rev: A
October, 2006
Parameter name DeltaV text Recommended actions
enable
mask
(show)
enable
mask
(show)
enable
mask
(show)
bad_position_sensor Bad Position Sensor Feedback problem, replace Control module
when possible
nny y nn
bad_temperature_sensor Bad Temperature
Sensor
Temperature sensor problem, replace
Control module when possible
nny y nn
system_temperature_exceeded System
Temperature
Exceeded
Take corrective actions to bring
temperature within specified range.
nny y nn
software_error Software Error Software error has been detected, replace
control module when possible.
nny nnn
travel_deviation Travel Deviation Lost position, Check air pressure y y n n n n
shutdown_is_set Shutdown Is Set Internal communications problem, check
shutdown configuration for restart, Replace
Control module.
nnn nyy
undefined_error Undefined Error Error is undefined, replace control module
when possible
nny nnn
cm_life_exceeded Control Module Life
Cycle Exceeded
Control module life cycle exceeded,
replace control module
nny y nn
pm_life_exceeded Pneumatic Module
Life Cycle
Exceeded
Pneumatic module life cycle exceeded,
replace pneumatic module.
nnn nnn
act_life_exceeded Actuator Life Cycle
Exceeded
Actuator life cycle exceeded, replace
actuator.
nnn nnn
valve_life_exceeded Valve Life Cycle
Exceeded
Valve life cycle exceeded,valve requires
maintenance.
nnn nnn
time_in_position_exceeded Time in position
exceeded
Time in position exceeded, take
appropriate action.
nnn nnn
open_travel_time_exceeded Close travel timer
exceeded
Open travel timer exceeded, check valve
system.
nnn nnn
close_travel_time_exceeded Close travel timer
exceeded
Close travel timer exceeded, check valve
system.
nnn nnn
initialization_failed Initialization Failure Device failed initialization; Check
airpressure, check actuator sizing, check
valve system
yyn nnn
Internal alerts
Counter alerts
Timer alerts
Alerts
Table 4.3 FieldQ™ Alerts & recommended actions
MaintenanceAdvisory Fail
Initialization alert
Alert default setting
