1-7
Installing Management Center for Cisco Security Agents 5.2
78-17916-01
Chapter 1 Preparing to Install
System Requirements
To run the Cisco Security Agent on your Solaris server systems, the requirements
are as follows:
Ta b l e 1-3 Agent Requirements (Solaris)
System Component Requirement
Processor UltraSPARC 400 MHz or higher
Note Uni-processor, dual processor, and quad
processor systems are supported.
Operating Systems Solaris 9, 64 bit, patch version 111711-11 or
higher, and 111712-11 or higher installed.
Solaris 8, 64 bit 12/02 Edition or higher (This
corresponds to kernel Generic_108528-18 or
higher.)
Note If you have the minimal Sun Solaris 8
installation (Core group) on the system
to which you are installing the agent, the
Solaris machine will be missing certain
libraries and utilities the agent requires.
Before you install the agent, you must
install the "SUNWlibCx" library which
can be found on the Solaris 8 Software
disc (1 of 2) in the /Solaris_8/Product
directory. Install using the pkgadd -d .
SUNWlibCx command.
Memory 256 MB minimum
Hard Drive Space 50 MB or higher
Note This includes program and data.
Network Ethernet
Note Maximum of 64 IP addresses supported
on a system.
