3-65
Catalyst 2955 Hardware Installation Guide
78-14944-03
Chapter 3 Installation
Connecting to 100BASE-FX MM Ports
Connecting to 100BASE-FX MM Ports
Warning
Class 1 LED product.
Statement 1027
The 100BASE-FX MM fiber-optic uplink ports operate in full-duplex mode.
You can connect a 100BASE-FX port to a port on a target device by using one of
the MT-RJ fiber-optic patch cables listed in Table B-1 on page B-3. Use the Cisco
part numbers in Table B-1 to order the patch cables that you need.
Caution Do not remove the dust plugs from the fiber-optic ports or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the fiber-optic ports and cables from contamination and ambient light.
Follow these steps to connect the switch to a MM 100BASE-FX device:
Step 1 Remove the dust plugs from the 100BASE-FX port, as shown in Figure 3-36, and
store them for future use. Remove the rubber caps from the MT-RJ patch cable.
Store them for future use.
Figure 3-36 Removing Dust Plugs from 100BASE-FX Ports
13
14
100Base-FX MM
87053
