MEGAPOWER CPU 8200-0421-03, REV. G
ADMINISTRATOR’S GUIDE
12 of 82
capabilities as indicated by the Access Denied
message if the following procedure is attempted.
a. Press and hold the Shift (
) button and then
press the Menu (
) button.
b. Enter one of the following number sequences
for your MegaPower CPU installation:
○ Standalone MPCPU: Enter 100.
○ Dual MPCPU: Enter 100 for the selected
MegaPower CPU, or enter 101 for the
Standby MP CPU.
c. Press Enter (
).
Note: Whenever scrolling to a different line
item on the LCD screen, you must press
twice to select the new item.
Note: To exit Program Mode, press and hold the
Shift (
) button, and then press the Clear ( )
button.
ADTTE:
a. Place the keyboard in Program Mode
(indicated by –P being displayed at the far right
of the LCD).
b. Press Menu. The LCD screen displays P6 - M.
c. Enter one of the following number sequences
for your MegaPower CPU installation:
○ Standalone MPCPU: Enter 100
○ Dual MPCPU: Enter 100 for the selected
MegaPower CPU, or enter 101 for the
Standby MP CPU.
d. Press the Ack key located in the lower right
corner.
The System Menu screen (
Figure 17) appears on
the LCD screen.
Note: To exit the LCD Menu Mode, press Menu.
Figure 17. System Menu screen
3. Press Enter to choose Addressing. The Address
Menu screen appears.
Figure 18. Address Menu screen
4. Press Enter to choose the IP Address. The IP
Address screen appears.
Figure 19. IP Address screen
5. Scroll down to Set IP Addr and press Enter. The
Set IP Address screen appears.
Figure 20. Set IP Address screen
6. Scroll down to Set IP Addr and press Enter. The
Enter IP Address screen appears.
Figure 21. Enter IP Address screen
7. Press Enter, and then type the IP address
pressing Enter twice after typing each segment of
the IP address.
8. Scroll down to Accept and press Enter.
9. Exit from the MegaPower CPU menu system.
Firewall Setup
To set up the firewall, refer to APPENDIX D: Port
Number Assignments on page
68 for the
appropriate MPCPU IP port source and destination
port numbers. Assigning these port numbers allows
communication with external devices.
Read Cycle
During a Read cycle, data is transferred from the
CPU to a PC running EASY CPU. The following
