Filter
Top Products
23
7. Press
RUN
PRGM
once. The display will show the
correct time and room temperature alter-
nately.
Select Heating and Cooling Temperatures
During programming, if you don’t press any
buttons for 5 minutes, the thermostat will enter
the HOLD mode and will maintain a constant
temperature. The display will revert to the alter-
nating time/temperature display. To resume pro-
gramming after this happens, press
VIEW
PRGM
until
you are at the point where you stopped program-
ming. Then you may continue to enter your
programs normally. If you want to stop program-
ming at any time, simply press
RUN
PRGM
to resume
program operation.
1. Press
SYSTEM
HEAT - OFF - COOL
until HEAT is displayed.
2. Press
VIEW
TEMP
once. The display will continue
to show HEAT. Below HEAT is the letter A,
representing the first programmed heating
temperature (HEAT A). At the right of the
display is the currently programmed HEAT
A setting.
3. Press either or to change the
temperature to your selected HEAT A set-
ting. (If you only want to program a tempera-
ture for HEAT A, skip to step 7.)
4. Press
VIEW
TEMP
once. The letter A will change to
the letter B, representing HEAT B.
5. Press either or to change the
temperature to your selected HEAT B setting