Whirlpool WHES20 Water System User Manual


 
26
Maximum Days Between Regenerations
The water sof tener automatically controls regeneration fre quency. This provides the greatest oper ating
efficien cy, and under most conditions, this feature should be left in this mode . However, modify this
feature if you want to force a regeneration every set number of days. For example, if your water supply
contains iron and you want the softener to regenerate at least once every few days to keep the resin
bed clean, set the display as shown below. Setting is available from 1 to 15 days by using the UP and
DOW N buttons.
NOTE:
The softener willrecha rge on its ow n if needed, even if itis before the setnumber of days.
1. Press and hold the
PROGRAM button until the following sc reen is displayed.
Once in this display, press the PROGRAM button four times and following display is shown.
2. Press the
+
Up or
Down buttons to set number of days.
12 or 24 Hour Clock
All time displays are shown in standard clock time (1 to 12 PM; and 1 to 12 AM) at the 12 hr default
setting. If 24 hour clock displays are desired, f ollow steps below.
1. Press and hold the
PROGRAM button until the following sc reen is displayed.
Once in this display, press the PROGRAM button five times and the following display is
shown.
12 Hour Clock I nitiated 24 Hour Clock I nitiated
2. Press the
+
Up or
Down buttons to set clock.
If you have questions about installation, progr amming, oper ating and routine maintenance...
call 1--866--986--3223, Monday -- Friday, 8 am to 9 pm, EST.