Filter
Top Products
23
Customizing Features/Options-- Model WHES30
Recharge
Recharge button is used to i nitiate a n immediate recharge.
• Press and hold the
RECHARGE button until the words “RECHARGE”, “SERVICE”
and “FILL” flash in the display, and the softener enters the fill cycle of regeneration right
awa y. The word “RECHARGE” will flash during the regeneration. When ove r, full water
conditioning ca p acity is restored.
RECHARGE NOW Initiated
NOTE:
Avoid usinghot water while the conditioneris regenerating, because the water heaterwill
refill with bypass hard water.
Recharge Scheduled
If you do not want to start an immediate recharge, but would like an extra recharge at the next preset
recharge time, do the f ollowing to schedule a recharge.
• Press and release (do not hold) the
RECHARGE button. The words “ RECHARGE
SCHEDULED” flashes in the display, and the softener will recharge at the next recharge
time. The word “RECHARGE” will flash during the regeneration. When over, full water
conditioning ca p acity is restored.
SetSaltLevel
The water softener has a sa lt monitor indicator light to remind you to refill the storage tank with salt.
• To set this monitor system, lift the salt hole cover and level the salt in the storage tank.
The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe
the number the leve led salt is at, or closest to. Now, press the
SET SALT LEVEL
button until black ovals corespond to the salt level number. At level 2 or below, the
indicator LED will flash “Check Salt Level”.
• If you want to turn the salt monitor off, press the SET SALT LEVEL button until
“SALT LEVEL OFF” shows in display.