Whirlpool EE2H40RD045V Water Heater User Manual


 
Location Requirements
Site location
Select a location near the center of the water piping
system. It must be installed indoors and in a vertical
position on a level surface.
The water heater should be located in an area not
subject to freezing temperatures. Water heaters located
in unconditioned spaces (i.e., attics, basements, etc.)
may require the water piping and drain piping to be
insulated to protect against freezing. The drain and
controls must be easily accessible for operation and
service.
Do not use this water heater in conjunction with a spa
or hot tub.
Note: Local codes and requirements in your area may
require the water heater to be installed such that the
bottom element is elevated from the floor at least 18
inches.
4
Note: The water heater shall be located so it is not
subject to physical damage by moving vehicles or area
flooding.
State of California
Note: The water heater must be braced, anchored, or
strapped to avoid moving during an earthquake. Contact
local utilities for code requirements in your area or call
1-877-817-6750 and request instructions.
Important: The water heater should be located in an
area where leakage of the tank or connections will not
result in damage to the area adjacent to the water
heater or to lower floors of the structure. Due to the
normal corrosive action of the water, the tank will
eventually leak after an extended period of time.
Also any external plumbing leak, including those
from improper installation, may cause early
failure of the water tank due to corrosion if not
repaired. If the homeowner is uncomfortable with
making the repair a qualified service technician
should be contacted. It is recommended that a
suitable drain pan be installed under the water heater
as shown below. This pan is to protect the property
from damage which may occur from normal
condensate formation on the tank or leaks in the tank
and pipe connections. The pan must limit the water
level to a maximum depth of 2-1/2 inches and be two
inches wider than the heater and piped to an
adequate drain. Locate the water heater near a
suitable indoor drain. Outdoor drains are subject to
freezing temperatures which can obstruct the drain
line. The piping should be at least 3/4”ID and pitched
for proper drainage.
Under no circumstance will the manufacturer or
seller of this water heater be held liable for any
water damage is caused by your failure to follow
these instructions.
2 1/2” Max
Pipe to
adequate
drain
At least 2” inches greater than
the diameter of the water
heater.
Figure 1
Residential Garage
Installation
Vehicle
Stop
Drain
Drain
Pan