Filter
Top Products
Starting the air conditioner using the
control panel
1. Select an operating mode by pressing the
ON/MODE A (up) or V (down) pads until the
indicator light next to the desired mods is lit.
The compressor and fan run until
the temperature setting is satis-
COOLS
The compressor and fan run until
the temperature setting is satisfied.
Then both cycle on and off to keep
the temperature constant.
gi
and pulls excess moisture out of
NOTE:
The COOLS setting saves energy by
cycling the fan on and off.
2. Select a fan speed by pressing the FAN
SPEED pad.
The unit always starts in AUTO
fan speed. Each press of the pad advances
the fan speed through the speed cycle.
HIGH -+ MED + LOW + HIGH
NOTE:
Once the FAN SPEED pad is pressed,
the only way to return to AUTO fan speed
from the Control Panel is to turn the unit off,
wait 3 minutes, and turn the unit on again.
In AUTO fan speed,
the unit automatically
selects a temperature setting according to the
room temperature. If room temperature is 78’
or above, the unit cools to 75’. If room
temperature is 77” or below, the unti cools to
3” below room temperature.
3. Set the desired temperature by pressing
the TEMP A (up) or V (down) pads until
the indicator light(s) next to the desired
temperature is lit.
For continuous cooling
when using the COOL or COOL* modes, set
the temperature to 65’.
When 2 indicator lights are lit, the selected
temperature is l/2 way between the two
temperatures. For example, if the indicator
lights for 65” and 70” are lit, the selected
temperature is 67.5”.
The OFF pad
The OFF pad turns the air conditioner off. You
can turn the air conditioner on again by following
steps l-3 above.
8