Filter
Top Products
Installation Instructions
Continued
Installing in a new sleeve
1. Remove the front and back covers. Save
these for future use to seal the sleeve if the
air conditioner is removed.
2. Remove the rear grille from the sleeve.
3. Brush out all debris from inside the sleeve
making sure the inside is clean and that the
drain holes are completely clear.
4. Loosen screws in the rear grille to about W
Then, while holding on to the wire loop, tip the
grille and pass it through the rear opening of
the sleeve. The baffle contact area should be
on the left.
5. Align the grille to engage the screw heads
through the keyhole slots in the outer flanges
of the sleeve. Push downward until the screws
are positioned into the bottom of the keyhole
slots. Tighten all 4 screws, and unwind and
discard the wire loop.
6. Unpack the air conditioner according to
the carton instructions.