Whirlpool 1328891 Air Conditioner User Manual


 
9
Mode
1. Press MODE repeatedly until you see the symbol glow for the
desired setting.
2. Choose Cooling, Dry, or Fan Only.
Cooling—Cools the room. Press FAN SPEED to select
Auto, High, Mid or Low. Press the up or down Adjust
button to adjust the temperature.
Dry—Dries the room. The air conditioner automatically
selects the temperature. The fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room.
Fan Only—Only the fan runs. Press FAN SPEED to select
High, Mid or Low.
NOTE: Auto fan speed cannot be selected in Fan Only
mode.
RapidCool
TM
Control
Used for fast cooling. The air conditioner automatically sets the
fan speed to High and the temperature to 64°F (18ºC).
1. Press RAPIDCOOL
TM
control. The air conditioner
automatically sets the fan speed to High and the temperature
to 64ºF (18ºC).
2. To turn off RapidCool
TM
control, press any button on the
remote control or control panel except Timer On, Timer Off
and Swing.
Fan Speed
1. Press FAN SPEED repeatedly to choose the desired fan
speed.
2. Choose Auto, High, Mid or Low.
Auto—automatically controls the fan speed depending on
the current room temperature and temperature control
setting.
NOTE: Auto fan speed cannot be selected in Fan Only
mode.
High—for maximum cooling
Mid—for normal cooling
Low—for quieter cooling
Filter Reset
1. When the Filter Reset indicator light is lit, remove, clean and
replace the air filter. See “Cleaning the Air Filter.”
2. Press and hold FILTER RESET for 3 seconds after replacing
the air filter.
NOTE: After 360 hours of fan operating time, the Filter Reset
indicator light will turn on. It will remain on for 180 hours or until
you press FILTER RESET. After 180 hours, the Filter Reset
indicator light will turn off automatically.
Temperature
Press the up Adjust button to raise the temperature. Press the
up Adjust button once to increase the set temperature by 2ºF
(1ºC), or press twice to increase the set temperature by 4ºF
(2ºC).
Press the down Adjust button to lower the temperature. Press
the down Adjust button once to decrease the set temperature
by 2ºF (1ºC), or press twice to decrease the set temperature
by 4ºF (2ºC).
NOTES:
In the Cooling mode, the temperature can be set between
64ºF and 90ºF (18ºC and 32ºC).
In Fan Only mode, the temperature cannot be set.
Mode
Fan
Speed
Filter
Reset