Whirlpool 1328891 Air Conditioner User Manual


 
8
4. Insert the foam seal behind the top of the lower window sash
and against the glass of the upper window.
5. Plug into a grounded 3 prong outlet.
6. Press RESET on the power supply cord. See “Electrical
Requirements.”
PORTABLE AIR CONDITIONER USE
Operating your portable air conditioner properly helps you to
obtain the best possible results.
This section explains proper portable air conditioner operation.
IMPORTANT:
The air conditioner display shows the current room
temperature and 24-hour clock.
When changing modes while the air conditioner is operating,
the compressor will stop for 3 to 5 minutes before restarting.
If a button is pressed during this time, the compressor will not
restart for another 3 to 5 minutes.
In Cooling or Dry mode, the compressor and condenser fan
will stop when the room temperature reaches the set
temperature.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
Starting Your Portable Air Conditioner
1. Select the mode. See “Mode.”
2. Select the fan speed. See “Fan Speed.”
3. Set the temperature. See “Temperature.”
4. Press ON/OFF to start the air conditioner.
NOTE: When the air conditioner is turned on for the first time
after it is plugged in, it will run in the 6
th
Sense
TM
System
control. When the air conditioner is turned on at all other
times, it will run according to the previous settings. 6
th
Sense
TM
System control can be selected with the remote
control only.
5. When the WATER FULL indicator light glows red, the air
conditioner will turn off automatically. See “Portable Air
Conditioner Care” for directions on draining the air
conditioner.
A.Top of lower window sash
B.Foam seal
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Timer
Swing
RapidCool
Adjust
Fan
Speed
Mode
On/Off
Filter
Reset
Water
Full
On
Off
On/Off
Water
Full