Filter
Top Products
6
Install side lock on the second section from the bottom
of the door. Square side lock assembly with door sec-
tion and hole in vertical track. The side lock should be
spaced approximately 1/8” from the section edge. Secure
the side lock to the section with (4) 1/4-20 x 11/16” self
drilling screws.(see Fig. 11)
IMPORTANT! Side locks and openers should not be
engaged at the same time. If an opener is installed on
the door and engaged, be sure side locks are disengaged,
otherwise damage could result to door and/or opener.
Only use side locks when opener is disengaged from
the garage door.
Side Lock Installation
WINDLOAD
POST
SIDE LOCK
ALIGN WITH
HOLE IN
VERTICAL
TRACK
(4) 1/4-20 X 11/16”
SELF DRILLING
SCREWS
FIG. 11
FIG. 10
STRAP
JR. “A”
FRAME
(2) 1/4-20 X 11/16”
SELF-DRILLING SCREWS
FIG. 9
(2)STRAPS
HALF HINGE
3-1/2” LG.
CARRIAGE BOLT
WING
NUT
1/8”
Loosely attach (2) straps to each center hinge, with (1)
3” long carriage bolt and wing nut (see Fig. 8). Attach
(2) straps to the bottom half hinge, with (1) 3-1/2” long
carriage bolt and wing nut (see Fig. 9). Position the straps
at each center hinge, and bottom half hinge locations.
Ensure that the windload post is plumb while locked into
the header lock bracket and hole in fl oor. Now, secure
each strap to the windload post using (1) 1/4-20 x 11/16”
self-drilling screw.
NOTE: Keep straps parallel and level. (see Fig. 10)
Finish hand tightening the carriage bolts and wing
Strap Bracket Installation
3” LG.
CARRIAGE BOLT
WING
NUT
(2) STRAP
FIG. 8
CENTER
HINGE