Filter
Top Products
FIGURE 14
PAGE 14
LIGHTING PROCEDURE FOR BOILER WITHLIGHTING PROCEDURE FOR BOILER WITH
LIGHTING PROCEDURE FOR BOILER WITHLIGHTING PROCEDURE FOR BOILER WITH
LIGHTING PROCEDURE FOR BOILER WITH
INTERMITTENT PILINTERMITTENT PIL
INTERMITTENT PILINTERMITTENT PIL
INTERMITTENT PIL
OO
OO
O
T SYT SY
T SYT SY
T SY
STEMSSTEMS
STEMSSTEMS
STEMS
..
..
.
FOR YOUR SAFETY READ BEFORE OPERATING.
A. This appliance is equipped with an ignition device which automatically lights the pilot.
Do not try to light the appliance by hand.
B. Before operating, smell all around the appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than air and will settle on the floor.
CACA
CACA
CA
UTION:UTION:
UTION:UTION:
UTION:
WHAT TO DO IF YOU SMELL GASWHAT TO DO IF YOU SMELL GAS
WHAT TO DO IF YOU SMELL GASWHAT TO DO IF YOU SMELL GAS
WHAT TO DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electrical switches; do not use any phones in your building.
* Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier's
instructions.
* If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob
will not push in or turn by hand, don’t try to repair it. Call a qualified service technician. Force
or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system and
any gas control which has been under water.
OPERAOPERA
OPERAOPERA
OPERA
TING INSTRTING INSTR
TING INSTRTING INSTR
TING INSTR
UCTIONS FORUCTIONS FOR
UCTIONS FORUCTIONS FOR
UCTIONS FOR
INTERMITTENT PILINTERMITTENT PIL
INTERMITTENT PILINTERMITTENT PIL
INTERMITTENT PIL
OO
OO
O
T SYT SY
T SYT SY
T SY
STEMSSTEMS
STEMSSTEMS
STEMS
1.
STOP!STOP!
STOP!STOP!
STOP! Read the safety information in the User’s Information Manual.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which automatically lights the pilot.
Do not try to light the pilot by hand. See figure 14 below.
5. Remove access panel.
6. Turn gas control knob clockwise to “OFF”.
7. Wait (5) minutes to clear out any gas.
If you then smell gas,
STOP!STOP!
STOP!STOP!
STOP! Follow “What
To Do If You Smell Gas” in the safety
information above. If you don’t smell gas, go
on to the next step.
8. Turn gas control knob counterclockwise
to “ON”.
9. Replace access panel.
10. Turn on all electric power to the
appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate,
follow the instructions “To turn off gas to
appliance”, on page 16, and call a qualified
service technician or your gas supplier.