Univex IT Series Carbon Monoxide Alarm User Manual


 
Model 5100-02-IT Combustible Gas Sensor Module
Page: 18
Function Display Description Reference
M E
ST
M E
ST
M E
ST
M E
ST
ME
S T
ME
S T
ME
S T
ME
S T
M E
ST
M E
ST
Use
S
or
T
keys to adjust to new set point
ME
S T
M E
ST
M E
ST
ME
S T
M E
ST
ME
S T
ME
S T
Table 4-3A Set-Up Configuration
Down *Sentry High Alarm Relay set to Sentry
Down Sentry
NOTE: Sentry indicates that Sentry controls relay
action and not the IT Sensor Module
Enter Latch
Use
S
or
T
keys to adjust to new relay action
(Latch, Sentry, NonLatc) * indicates current
Down L.Relay S.P. Function - Low Alarm Relay Adjust
Relays Set Point Adjustment Example
Enter H. Relay S.P. Function - High Alarm Relay Adjust *B
H.Alarm S.P. Function - High Alarm Adjust
Enter ACK Momentary Acknowledge of new Set Point
Down (x5) HASP:55- High Alarm Set Point: new = 55
Enter HASP:60- High Alarm Set Point: current = 60
High Alarm Set Point Adjustment Example
Enter H.Alarm S.P. Function - High Alarm Adjust *A
Down RS-485 S.P. Function - RS-485/Sentry Output Adjust * E pg. 19
Down 4-20mA S.P. Function - 4-20 mA Adjust * D pg. 19
Down GasFactr S.P. Function - Gas Factor Adjust * C pg. 19
Down Relays S.P. Function - Relays Adjust * B Below
Enter Alarms S.P. Function - Alarm Adjust * A Below
Mode SETUP:--- Mode Function - Set Point Adjustments
Mode CALIB:-- Mode Function - Calibrate
Mode ALMRSET: Mode Function - Alarm Reset
Key
--0%LEL- Default Display