Filter
Top Products
12
INSTALLING TOP SURROUND & BRASS TRIM
INSTALLING TOP SURROUND
N
OTE: YOU WILL NEED A FLATHEAD SCREW-
DRIVER AND A 3/8" NUT-DRIVER TO ATTACH THE
SURROUND
AND BRASS TRIM.
The top surround is shipped unassembled for
shipping purposes only. To install the top
surround place the surround on top of the unit
and line up the holes. Attach the top surround
to the heater using (5) of the machine screws
and kep nuts provided in the parts bag and
tighten firmly.
BRASS KNOB INSTALLATION
For shipping purposes the brass knob on the lower access door comes mounted inside the door. Simply unscrew
the knob using a screwdriver, turn the knob around to the outside and reattach.
INSTALLING BRASS TRIM
Before attaching the brass trim to the surround you must first assemble the (3) brass trim pieces
together. Do this you will use the (2) blank corner keys and the (2) corner keys w/screws.
Place one each of the keys together for each side and slide them into the back grooves of the trim as
shown below. Tighten the set screws with a flathead screw driver. (Do this for both sides)
Now slide the Brass Trim Assembly over the surround and attach using the (9) remaining screws and
kep nuts provided in the parts bag.